Apc SMARTUPS Smart-UPS 700 User Manual download pdf (Page 15)

English

5. Operation

5.1 Switch On

With the unit plugged in, press the on/test (upper) button to supply power to the loads. The loads

are immediately powered while the unit beeps and performs a self-test. See section 5.3.

5.2 Switch Off

To switch off the unit’s output power, press the off (lower) button. It may be convenient to use the

on and off buttons of the unit as a master on/off switch for the protected equipment.

Note: The unit is on (the internal processor is operating) whenever it is plugged in and utility voltage

is present. Even when switched off the unit maintains the battery charge and will respond to com-

mands received through the computer interface port and the accessory slot.

5.3 Self-test

Use the self-test to verify both the operation of the unit and the condition of the battery. With the

unit plugged in to normal utility power, activate the self-test by pressing the on/test button until the

unit beeps and the on-line LED flashes.

Note: By default the unit performs a self-test at power up and once every two weeks.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

No comments

Apc SMARTUPS Smart-UPS 700 User Manual Page 15