APC 400V User Manual download pdf (Page 32)

Operation – Restart procedure

24 Smart-UPS® VT 10-40kVA, 400V, Operation Manual 990-2282

After system boot-up, the display will automatically prompt you on how to confirm/select voltage

and frequency as shown in the following.

Voltage confirmation

At the initial start-up, the display will prompt you through the following screens:

• When the Confirm Voltage prompt appears on the screen, use the arrow key on the display to

select desired voltage, and press ENTER.

• When the prompt Apply load appears, select Yes if you want the UPS to provide a load output

now. (If you do not want a UPS load output at this point, select No).

LOAD ON LED is now lit, and the display will show the Confirm Status Screen.

Note

Wait approximately 30 seconds for the system to boot up and perform a self test.

See display introduction under The Display.

Note

The UPS is now ready to support the load.

Note

Auto-detection on frequency - if problem occurs call APC Customer Support.

Confirm Voltage

Use 400V

Yes, use 400V

No, select another

Apply load?

Yes

Chrg xxx% ||||||||||

Load xxx% ||||||||||

xxx Vin xxxVout xxHz

Runtime: xxhr xxmin

Status screen

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 45 46

No comments

APC 400V User Manual Page 32