APC J15BLK Datasheet Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 56
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
1-11
Surge Protected COAX/RF Connectors
The surge protection feature prevents surges traveling over coaxial
data lines from damaging the system. Connect the coaxial cable
from the CATV or Cable Modem provider to the connector marked
IN”, connect other cables from the connectors marked “OUT” to
the device(s) being protected (CATV box or Cable Modem - in
some cases, the input for both are derived from the single cable
from the provider - such as TV and Internet access through the
same coaxial cable). The J15 model provides a cable splitter for
your CATV system or cable modem. Only the J10 model provides
for connection of a single output.
Additional Surge Protected COAX/RF Connectors
The J10 and J15 also provide surge protection for your satellite,
cable, or RF antenna system. The surge protection feature prevents
surges traveling over a coaxial cable from damaging the
equipment. Connect the coaxial cable from the satellite, cable, or
antenna system to the connector marked “IN”, connect another
coaxial cable from the connector marked “OUT” to the device
being protected (satellite, cable, or antenna).
CIRCUIT BREAKER – Provides a “press-to-reset” Circuit
Breaker, which when “tripped” due to an output overload, pops out
and shuts down output power to the outlets. To reset the Circuit
Breaker, push it straight inward.
Caution: When resetting the Circuit Breaker, push the button in
quickly, and release the button. Do not hold the Circuit Breaker
button inward. Failure to comply may result in equipment damage.
SYSTEM GROUND Screw
Provides for the connection of grounding wires from all of your
equipment to a central terminal screw. This ground connection
eliminates ground loop problems; tie all component grounds to this
terminal to break any possible ground loops that can cause an
audible ‘hum’.
BUILDING WIRING FAULT Indicator
If lit, then one of three wiring problems exists in the building
wiring circuit: missing ground, overloaded neutral, or reversed
polarity. An electrician should be consulted to resolve the problem.
2
3
4
!
5
!
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 55 56

Comments to this Manuals

No comments