APC J15BLK Datasheet download pdf (Page 24)

2-2

removed ﬁrst as described above. Lift each unit carefully by ﬁrmly grasping both

sides of unit in the middle. Failure to comply may result in personal injury and/or

equipment damage.

Place unit on a solid, ﬂat surface that is capable of supporting at least 50 lbs.

Note: Avoid placing other components directly on top of or behind the unit.

Leave at least one inch of space on all sides to allow for proper air

ventilation. Do not block the fan.

Inserting and Connecting the Battery

In accordance with APC’s interpretation of Department of Transportation

regulations, APC ships this device with the battery disconnected. The front bezel of

the unit is also not attached to the unit when shipped.

This procedure provides for connection of the battery when the front bezel has been

prematurely installed onto the chassis. Connect the battery as follows:

1. Grasp the front panel at the sides, and pull the front bezel from the unit.

2. Push the Battery Wire Connector (Figure 4) into the hole located at the left of the

Battery Pack. Ensure that the Battery Wire Connector is pushed into the hole and

securely connected by gently pulling on the wire to see if it is attached to the

connector.

Figure 4. Battery Wire Connection

3. Install the battery retaining bar.

4. Install the front Bezel, by aligning the four pins located on the back-side of the Bezel

to the holes at the left and right sides of the unit. Gently push the front Bezel onto the

unit.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

No comments

APC J15BLK Datasheet Page 24