APC NetShelter SX 42U Specifications download pdf (Page 12)

NetShelter SX Networking Enclosure—Unpacking, Installation, and Customization8

Removing the casters and leveling feet (optional)

Warning: To avoid personal injury or damage to the enclosure, two people should

support the enclosure.

The enclosure should be empty and the roof, side panels, and front and rear doors

should be removed before laying the enclosure on its side.

Tilt the enclosure in an area that will allow for proper clearance above the enclosure.

1. Lay the enclosure on its side.

2. Using a 10-mm socket wrench (not provided), remove the four hex nuts from each of the casters

and remove the casters.

3. For each leveling foot, use a Phillips or slotted screwdriver (not provided) to turn the foot

clockwise until it is released from the frame.

Rack stabilization options

Warning: The enclosure cannot be stabilized using the bolt-down bracket or

stabilization plate if the casters or leveling feet are removed.

Brackets can be used to bolt the enclosure to the floor internally or externally for additional stabilization.

With the appropriate anchoring hardware (not provided), this system meets UBC Zone 4 requirements.

See the APC Web site, www.apc.com, for complete UBC compliance requirements and bracket

installation instructions. All brackets can be fastened to the enclosure through the holes shown in the

following illustration.

ns0879b

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

No comments

APC NetShelter SX 42U Specifications Page 12