APC NetShelter SX 42U Specifications download pdf (Page 29)

25NetShelter SX Networking Enclosure—Unpacking, Installation, and Customization

Data Distribution

The 1-U and 2-U Data Distribution Panels are TIA-EIA-310-D-compliant and can be mounted on the

front or rear rails of an APC NetShelter or any other standard enclosure.

Installation

Install four caged nuts (two per side) into the upper- and lower-most holes at the desired mounting

location in the enclosure.

Secure the Data Distribution Panel in place using four M6 screws and four plastic cup

washers (two per side).

0-U installation

You can install panels in the left or right vertical 0U accessory channel on either side of the enclosure.

The following procedure shows left-channel, left-side installation for clarity. You can route cables from

the top or bottom of the rack. The procedure below shows top routing.

ns1564a

ns1076 b

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

No comments

APC NetShelter SX 42U Specifications Page 29