17NetShelter SX Networking Enclosure—Unpacking, Installation, and Customization
1. Use the Torx T30/#2 Phillips wrench (provided)
to loosen—but not remove—the Torx screws in
the slots of each mounting flange.
2. Lower the flat bracket and move the mounting
flange to the desired location.
3. To align the vertical mounting
flanges properly, note the symbol
(for example, the diamond)
visible through one of the holes
on the top of the flange, and
ensure that the same symbol is
visible through the corresponding
hole at the bottom of the flange.
Only one symbol is visible at a
time through any of the holes. In
the factory-standard position, the
diamonds are visible through two
of the holes.
Note: Ver ti cal
mounting flanges
adjust in 6-mm
(1/4-in) increments.
Vertical mounting
flanges placed across
from each other must
have the same visible
symbol.
Comments to this Manuals