APC AP9617 User Manual download pdf (Page 57)

USER’S GUIDE

network management card

From the Converters sub-menu, type 3 for Converter Status. Then at the

prompt, enter the number of a converter for a report of its status.

Status Field Description

Device Type The device type of the converter.

In Standby Reports Yes if the control unit is holding the converter in standby

mode.

Firmware

Version

The firmware revision of the converter device.

Conv Fail

Alarm

Reports Yes if the converter has failed.

PCB Serial No. The PCB (Printed Circuit Board) serial number of the converter.

Conv Voltage The system-level converter voltage.

Self Test Result Reports whether the converter has passed or failed its diagnostic

testing.

Conv Current The DC output current in amps.

Fan Fail Reports Yes if the converter fan has failed.

Current Limit Reports Yes if the converter has been forced into its current-limited

mode.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 103 104

No comments

APC AP9617 User Manual Page 57