APC RAID Subsystem SCSI-SATA II User's Guide Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 46
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
Introduction
96-00290-001 Rev. A1 DataDirect Networks StorageScaler 2460 User Guide | 6
1.7.1 Maintaining Correct Airflow and Cooling
In addition to supplying power, the APC units maintain proper airflow and cooling within the
enclosure.
Because there are two APC units, the enclosure can continue to operate even if one APC unit
fails.
The cooling fans in each APC unit run on separate circuits from the power supply. If one
APC unit fails, its fans continue to run on power supplied by the other APC unit.
However, for proper enclosure operation and cooling, two APC units with fully-functional
fans must be installed at all times. The enclosure can run temporarily (for no more than five
minutes) with a single APC unit while you install a new one—you must install a second APC
unit
as quickly as possible
to maintain correct airflow and cooling.
CAUTION ! Once you have removed a failed APC unit, you must replace it within five
minutes or the enclosure may overheat and shut down to prevent
hardware damage. This type of shutdown is immediate—unexpected
loss of data access and permanent data loss may occur.
1.8 Connection and Configuration Options
This section describes the different connection options for your SS2460 enclosure.
NOTE :
Unless otherwise noted, the enclosures in all these configurations support
SAS or SATA disk drives, but not a combination of both.
1.8.1 Basic Configuration–Single Controller System
Connect your SS2460 enclosure to a SAS/SATA HBA or SAS/SATA RAID card in a single host
system (Figure 8).
Figure 8. StorageScaler 2460 Single Host System
Host
StorageScaler 2460 Enclosure
As your storage space requirements change, you can upgrade and expand this basic
configuration.
NOTE :
In single I/O controller configurations the controller must be installed in Slot
A (on the left side of the enclosure as seen from the back of the enclosure).
To install or remove an I/O controller, see Section4.2.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 45 46

Comments to this Manuals

No comments