APC RAID Subsystem SCSI-SATA II User's Guide download pdf (Page 20)

Installation

96-00290-001 Rev. A1 DataDirect Networks StorageScaler 2460 User Guide | 14

2.4 Installing the Disk Drives

CAUTION ! Acclimate new disk drives to room temperature before you install them.

Store drives at room temperature for two hours prior to use.

NOTE :

Combining SAS and SATA disk drives in this enclosure is not supported at

this time. Please use either SAS or SATA disk drives, but not both.

To install a disk drive:

1. Press the release button to release the lever on

the carrier.

2. Hold the disk drive so that th

e LEDs are on the bottom and the lever is fully open.

3. Slide the disk drive into the driv

e slot until the lever starts to close (Figure 18).

Figure 18. Disk Drive Inserted in Drive Slot

4. Gently push the lever until it mates with the latch on the bottom of the drive slot and

clicks into place (Figure 19).

Figure 19. Lever Latched

NOTE :

To maintain proper airflow and cooling, a disk drive or a blank drive carrier

must be installed in every slot of the enclosure.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

No comments

APC RAID Subsystem SCSI-SATA II User's Guide Page 20