APC Galaxy 3000 User Manual download pdf (Page 46)

www.mgeups.com

Network

Management Cards

User Manual

THE UNINTERRUPTIBLE POWER PROVIDER

Network Management Card

– User Manual 34003676EN/BB Page 46/76

◗ Name and status of each contact can be configured

◗ Recording of events and measurements in the card log

◗ Possibility of shutting down the installation safely if one of the thresholds is exceeded or if a dry contact

closes

◗ Connection to the Network Management Card by CAT5 straight RJ45 network cables (maximum

card/sensor distance: 20m)

3.6.2 Environment status

For both measurements, a graduated gauge proposes the following functions:

The cursor indicates the current value.

Two red zones to the left and right represent the high and low thresholds that can be set on the Environment

Settings page.

When the measured value enters one of these zones, a alarm can be notified (see Notification parameter in

the Environment Settings page).

Time-stamped minimum and maximum temperatures show the extreme values recorded since the last Reset

Min/Max, a thin dotted line shows their positions on the gauge.

Min and Max can be forced at any time to the current value by clicking on the Reset Min/Max button.

Calibrate: the sensor is calibrated in the factory, but the user can apply an offset to adjust the measurement.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 75 76

No comments

APC Galaxy 3000 User Manual Page 46