APC MGE Galaxy 7000 User Manual download pdf (Page 14)

Network Management Card & Modbus/Jbus 34022321XT indice :AD Page 14/91

Network Management Teleservice Card

APC by Schneider Electric

www.apc.com

Ethernet port

LED Colour Activity Description

ACT Green ◗ Off ◗ Card not connected to the network.

◗ On

◗ Card connected to the network but

without activity

◗ Flashing

◗ Port is active in receiving /

transmission

100M Orange ◗ Off ◗ Port operating at 10Mbits/s.

◗ On ◗ Port operating at 100Mbits/s.

Service port (Settings/Sensor)

LED Colour Activity Description

UPS Green ◗ Off ◗ Card startup in progress.

Data ◗ On ◗ Communication with UPS in progress

◗ Flashing

◗ Normal operation.

Communication with the UPS is

operational

RS232 Orange ◗ Off ◗ Configuration menu is active

◗ On ◗ Normal operation. Configuration

menu is deactived

◗ Flashing ◗ Communication with the Environment

Sensor (option).

3.3 Installation in the UPS

The Network Management Card (66123) can be "hot" installed in the MGE Galaxy 7000 UPS or SSC unit.

Note the card's MAC address prior to insertion

Connect the ETHERNET cable

Insert and tighten the card's retaining screws

Wait 3 min.; the card is completely operational when the green UPS Data LED flashes continuously

3.4 Sensor installation (option)

The Environment sensor is available as an option on the Network Management Card. SKU number is 66846.

The sensor allows remote monitoring of the UPS's environment through regular measurements: temperature, humidity, status of two external

contacts. It also enables notification of alarms (e-mail, trap SNMP) according to pre-programmed thresholds.

It is connected to the Service port (Settings/Sensor) directly on the Network Management Card with a standard Ethernet cable (20 meters

maximum).

Recognition is automatic. Supervision and configuration are performed via a menu that can be accessed directly from the home page.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 90 91

No comments

APC MGE Galaxy 7000 User Manual Page 14