APC MGE Galaxy 7000 User Manual download pdf (Page 20)

Network Management Card & Modbus/Jbus 34022321XT indice :AD Page 20/91

Network Management Teleservice Card

APC by Schneider Electric

www.apc.com

5.1.2 Your network is not equipped with a DHCP server

In the main menu enter 2, then 2 again. The menu is displayed:

Follow the instructions and enter the static IP parameters.

At the end of the menu, wait for the "Done" message to be displayed indicating that the IP parameters have been saved.

-----------------------------------------------------------------------------

Network settings

-----------------------------------------------------------------------------

1 : Read Network settings

2 : Modify Network settings

3 : Set Ethernet speed

0 : Exit

-----------------------------------------------------------------------------

For each of the following questions, you can press <Return> to select the value

shown in braces, or you can enter a new value.

Should this target obtain IP settings from the network?[N] N

Static IP address [172.17.21.94]? 172.17.21.21

Static IP address is 172.17.21.21

Subnet Mask IP address [255.255.248.0]? 255.255.255.0

Subnet Mask IP address is 255.255.255.0

Gateway address IP address [172.17.17.1]? 172.17.17.1

Gateway address IP address is 172.17.17.1

Wait during your new configuration is saved ...

Reset the card to take into account the new configuration.

Return to the main menu and enter 1 then 2.

The card restarts with the new IP parameters.

5.2 Test after configuration

To check that the Network Management Card is operational after installation and configuration.

From a station connected to the same subnet as the card, open a web browser and enter the IP address of the card in the address field.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 90 91

No comments

APC MGE Galaxy 7000 User Manual Page 20