Network Management Card & Modbus/Jbus 34022321XT indice :AD Page 16/91
Network Management Teleservice Card
APC by Schneider Electric
www.apc.com
Ethernet port
LED Colour Activity Description
ACT Green ◗ Off ◗ Card not connected to the network.
◗ On
◗ Card connected to the network but
without activity
◗ Flashing
◗ Port is active in receiving /
transmission
100M Orange ◗ Off ◗ Port operating at 10Mbits/s.
◗ On ◗ Port operating at 100Mbits/s.
Service port (Settings/Sensor)
LED Colour Activity Description
UPS Green ◗ Off ◗ Card startup in progress.
Data ◗ On ◗ Communication with UPS in progress
◗ Flashing
◗ Normal operation.
Communication with the UPS is
operational
RS232 Orange ◗ Off ◗ Configuration menu is active
◗ On ◗ Normal operation. Configuration
menu is deactived
◗ Flashing ◗ Communication with the Environment
Sensor (option).
Phone port
LED Colour Activity Description
UPS Green ◗ Off ◗ Card not connected to phone network
Data
◗ On
◗ Card connected to phone network,
but no activity
◗ Flashing ◗ Port is sending/receiving
CD Orange ◗ Off ◗ Modem is not connected
◗ On ◗ Modem is connected
◗ Flashing ◗ Modem is connecting
4.3 Installation in the UPS
The Network Management Teleservice Card (66124) can be "hot" installed in the MGE Galaxy 7000 UPS or SSC unit.
Note the card's MAC address prior to insertion
Connect the ETHERNET cable
Insert and tighten the card's retaining screws
Wait 3 min.; the card is completely operational when the green UPS Data LED flashes continuously
For Teleservice installation, the NMTC card must be installed in the SSC unit.
4.4 Sensor installation (option)
The Environment sensor is available as an option on the Network Management Card. SKU number is 66846.
The sensor allows remote monitoring of the UPS's environment through regular measurements: temperature, humidity, status of two external
contacts. It also enables notification of alarms (e-mail, trap SNMP) according to pre-programmed thresholds.
Comments to this Manuals