APC SU1400XLT User Manual Page 95

  • Download
  • Add to my manuals
  • Print
  • Page
    / 115
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 94
The UPS model as derived from information from the UPS.
UPSMODE
The mode in which apcupsd is operating as specified in the configuration file (UPSMODE)
STARTTIME
The time/date that apcupsd was started.
STATUS
The current status of the UPS (ONLINE, ONBATT, etc.)
LINEV
The current line voltage as returned by the UPS.
LOADPCT
The percentage of load capacity as estimated by the UPS.
BCHARGE
The percentage charge on the batteries.
TIMELEFT
The remaining runtime left on batteries as estimated by the UPS.
MBATTCHG
If the battery charge percentage (BCHARGE) drops below this value, apcupsd will shutdown your
system. Value is set in the configuration file (BATTERYLEVEL)
MINTIMEL
apcupsd will shutdown your system if the remaining runtime equals or is below this point. Value is set
in the configuration file (MINUTES)
MAXTIME
apcupsd will shutdown your system if the time on batteries exceeds this value. A value of zero
disables the feature. Value is set in the configuration file (TIMEOUT)
MAXLINEV
The maximum line voltage since the UPS was started, as reported by the UPS
MINLINEV
The minimum line voltage since the UPS was started, as returned by the UPS
OUTPUTV
The voltage the UPS is supplying to your equipment
SENSE
The sensitivity level of the UPS to line voltage fluctuations.
DWAKE
The amount of time the UPS will wait before restoring power to your equipment after a power off
condition when the power is restored.
DSHUTD
The grace delay that the UPS gives after receiving a power down command from apcupsd before it
powers off your equipment.
DLOWBATT
The remaining runtime below which the UPS sends the low battery signal. At this point apcupsd will
force an immediate emergency shutdown.
LOTRANS
The line voltage below which the UPS will switch to batteries.
HITRANS
The line voltage above which the UPS will switch to batteries.
Page view 94
1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 114 115

Comments to this Manuals

No comments