APC SYMMETRA 990 User Manual download pdf (Page 22)

Symmetra MW II with Internal Bypass Static Switch - Operation - 990-1756C-00118

Note: The display will have to be rebooted in order for the changes to the domain name or

DNS servers to take effect.

3. Configure the E-mail Settings screen:

– Enable E-mail: Select to enable the e-mail

notifications.

– To add a new e-mail recipient, touch the

Add New button, type in the e-mail address

and specify the minimum severity of alarm.

All entries will appear in red until Apply

Changes is pressed.

– To edit or delete an e-mail recipient, select

the recipient from the recipient list, and then

choose to either update or delete it.

– Apply Changes: Press this button after all

changes have been made. Entries will appear in red until this button is touched.

– Send Test E-mail: Pressing this button sends a test e-mail to all configured e-mail recipients.

This button can be used to validate the e-mail settings.

– Press arrow down to go to the next Network Configuration screen.

4. Configure the SNMP Settings screen. The UPS

can be set to send SNMP traps if UPS alarm

conditions occur, and when the conditions

return to normal afterwards. Each trap contains

a description of the alarm condition. Up to 10

trap receivers can be entered. The trap receiver

must have the APC PowerNet MIB (version

3.6.1 or later). The latest version of the

PowerNet MIB can be downloaded from

www.apc.com.

– Enable SNMP: Enable the SNMP

functionality by selecting this checkbox.

– To add a new trap receiver, press the Add

New button, type in the address and specify the minimum severity of alarm. All entries will

appear in red until Apply Changes is pressed.

– To edit or delete a trap receiver, select the recipient from the recipient list, and then choose to

either update or delete them.

– Apply Changes: Press this button after all changes have been made. Entries will appear in red

until this button has been pressed.

– Send Test SNMP: Pressing this button sends a test trap to all configured trap receivers. This

button can be used to validate SNMP settings.

– Press arrow down to go to the next Network Configuration screen.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

No comments

APC SYMMETRA 990 User Manual Page 22