2.02 ACCESSORIES
A. Condensate Removal: Supply approved means to remove condensate for the furnace and MCHP.
PART 3 – EXECUTION
3.01 MANUFACTURER’S INSTRUCTIONS
A. Compliance: Comply with manufacturer’s product data, including product technical bulletins, product catalog
installation drawings and instructions.
B. Coordination: Coordinate electrical or mechanical requirements for these connections.
3.02 EXAMINATION
A. Site Verifi cation or Conditions: Verify that fl oor conditions are acceptable for product installation in accordance
with manufacturer’s instructions.
B. Footprint: Verify that fl oor space is acceptable for product installation in accordance with manufacturer’s
instructions.
C. Intake/Vent Pipe Routing: Verify that air intake and vent pipe chases and termination locations are acceptable for
product installation in accordance with manufacturer’s instructions.
D. Condensate Removal: Verify that condensate removal locations are acceptable for product installation in
accordance with manufacturer’s instructions.
3.03 INSTALLATION
A. Certifi cation: Verify that installers have valid certifi cation from the manufacturer to install and service the Warm
Air Micro-CHP System.
B. Warm Air Micro-CHP System: Install in accordance with manufacturer’s installation instructions.
C. Accessories: Install in accordance with manufacturer’s installation instructions.
END OF SECTION
GUIDE SPECIFICATION
Comments to this Manuals