APC AP9222 Datasheet download pdf (Page 9)

MasterSwitch VM User’s Guide 4

Introduction

Operating MasterSwitch VM

Initial setup

You must configure the network settings of MasterSwitch

before it

can operate on a network. The required settings are:

•

address of MasterSwitch

• Subnet Mask

•

address of the default gateway

Note: If a default gateway is not present, enter an

address

of a computer on the same subnet that is always active.

For instructions on configuring the MasterSwitch

network settings,

see the installation manual included with the unit and on the

. After

you have configured MasterSwitch

, no further configuration is

required. The remaining MasterSwitch

properties are pre-configured

at the factory. However, you may want to customize these properties for

your application. See

Menu Items on page 14

for more details on

changing MasterSwitch

properties.

Configuring

outlets for

operation

MasterSwitch

allows you to configure an outlet for on-demand

operation. On-demand operation consists of On, Off, and Reboot Outlet

Control Actions. The sections that follow desribe each operation that

you can configure for your MasterSwitch

unit.

Immediate On. This action immediately turns an outlet on.

Immediate Off. This action immediately turns an outlet off.

Immediate Reboot. This action immediately turns an outlet off, and

then turns it back on after the outlet’s Reboot Duration expires.

Outlet is on

Immediate Reboot

command is issued

Outlet is turned off

Cancel command

is issued

Reboot Duration

expires

Outlet remains

off

Outlet is turned

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 42 43

Comments to this Manuals

No comments

APC AP9222 Datasheet Page 9

Comments to this Manuals

Related products and manuals for Power distribution units (PDUs) APC AP9222