APC Rack PDU, Metered, Zero U, 5.7kW, 120V User's Guide download pdf (Page 14)

10 Metered Rack Power Distribution Unit

BOOTP. You can use an RFC951-compliant

BOOTP server to configure the TCP/IP settings for

the

PDU. If the BOOTP server is properly

configured, the

PDU’s default setting (DHCP &

BOOTP) for TCP/IP configuration causes it to

discover the BOOTP server.

1. Enter the

PDU’s MAC and IP addresses, the

subnet mask and default gateway settings, and

an optional bootup file name in the

BOOTPTAB file of the BOOTP server.

2. When the

PDU reboots, the BOOTP server

provides it with the TCP/IP settings.

If you specified a bootup file name, the PDU

attempts to transfer that file from the

BOOTP server using TFTP or FTP. The

PDU assumes all settings specified in the

bootup file.

If you did not specify a bootup file name,

the

PDU can be configured remotely by

using Telnet or by using the Web interface:

user name and password are both apc, by

default.

If a BOOTP server is unavailable, see

“APC Device IP Configuration

Wizard” on page 9, “Local access to

the control console” on page 12, or

“Remote access to the control console”

on page 13 to configure TCP/IP

settings.

For the MAC address, look on the back

of the PDU or on the Quality

Assurance slip included in the

package.

See also

To create a bootup file, see your

BOOTP server documentation.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comments to this Manuals

No comments