APC NBPD0160 Specifications download pdf (Page 17)

13NetBotz Rack Monitor 450/550 Installation and Quick Configuration Manual

Note: If the COM port associated with the port to which your USB cable is connected

is currently in use by another application, the message beside the COM port in the

Owner column indicates that the port is not available. To correct this, close the

application that is using the COM port and click Scan Serial Ports.

5. The Root Password window appears. Enter the administrator account password for this appliance

(apc, by default) and click OK.

6. Specify whether to use DHCP to specify the network settings of your appliance. Click Yes or No,

and click Next to continue.

7. The utility scans the appliance and displays the network settings stored on the appliance. The

network settings are divided into Ethernet Card Settings and DNS Settings.

8. Specify the Ethernet Card settings.

– To use network settings assigned by a DHCP server, select Configure automatically via

DHCP.

– To specify network settings for use by this appliance, select Configure using these settings

and provide an IP address, subnet mask, and gateway address for the appliance. Specify a NAT

proxy name or IP address to be used by a NAT Proxy server in your network to allow users to

connect to the appliance from outside the firewall. You can also specify speed and duplex

settings for use by this interface, or use the default setting, Auto Negotiate.

9. Specify the DNS Settings.

– To use DNS Settings provided by your DHCP server, check Use DHCP DNS Settings.

– To specify DNS Settings for this appliance manually, clear the Use DHCP DNS Settings

checkbox and provide the domain and DNS server information.

10.Click Next to save your configuration settings. Click Finish to close the Serial Configuration

Utility.

11.Test the IP connection of the NetBotz appliance. Start your Web browser and type the IP address

of the appliance into the address field. Press Enter. If the NetBotz appliance is online and

properly configured, the Basic View displays in the browser window.

Install a wireless network device

You can install a third-party wireless network device by connecting it to the Ethernet port on the

appliance using an Ethernet cable. APC currently supports the D-Link DWL-G820, a wireless Ethernet

bridge.

To install and configure a third-party wireless network device, see the instructions provided

with that device.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

No comments

APC NBPD0160 Specifications Page 17