APC ACRP500 Specifications download pdf (Page 30)

InRow RP CW Installation22

Leveling the Equipment

Note: The leveling feet at the corners of the equipment provide a stable base if the floor is

uneven, but they cannot compensate for a badly sloped surface.

1. Remove the front and rear doors. See “Removing the front and rear doors” on page 19.

Note: Before removing the front door, unplug the ground wires and any other wire

connections that may interfere with the removal of the doors.

2. For each leveling foot, insert a Phillips PH2 or

slotted screwdriver into the screw above the

leveling foot. Turn the screw clockwise to extend

the leveling foot until it makes firm contact with

the floor.

3. Reinstall the front and rear doors.

Caution: After reinstalling the front door, reconnect the ground wire and other wire

connections.

Note: Use a 13-mm open-ended wrench to level the equipment without removing the

doors.

na1572a

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 55 56

No comments

APC ACRP500 Specifications Page 30