APC SU1400XLT User Manual download pdf (Page 63)

The Network Management Card (AP9617, AP9618, AP9619) must be

configured with network settings before it can communicate on the

network. Once the cards have been configured with an IP address,

Subnet Mask, and Default Gateway the cards can be access, managed,

and controlled from other computers on the network.

There are two ways to configure the Network Management Card (NMC)

with its initial settings: the (windows) Wizard and Address

Resolution Protocol (ARP).

1. The wizard in included on the CD that comes with the card. The

wizard must run on a Windows operating system. You can configure

the card using the wizard over the network via FTP. If using the

wizard please note, the un-configured NMC must be on the same

subnet as the computer running the wizard.

2. Address resolution protocol (arp) can also be used to configure

the NMC. The MAC Address of the NMC is needed for this method of

configuration. The MAC address is located on the quality assurance

slip that is shipped with the NMC, and is also located on the white

sticker on the NMC itself. From a computer on the same subnet as

the un-configured NMC, follow the instructions:

Open up a command prompt and type the following (replacing

<IPaddress> and <MacAddress> with the actual values):

arp -s <IPaddress> <MacAddress>

Next, use Ping with a size of 113 bytes to assign the IP address

defined by the ARP command.

- Linux command format: ping <IPaddress> -s 113

- Windows command format: ping <IPaddress> -l 113

Set SNMP card General Parameters

After the SNMP Network Management Card is configured with an IP address, the SNMP Card is ready for

general configuration. This is accomplished by telneting to the SNMP Card.

~$ telnet <IPaddress>

*******************************************************************************

American Power Conversion Network Management Card AOS v2.6.4

-------------------------------------------------------------------------------

Name : Date : 07/03/2006

Contact : Time : 04:43:33

Location : User : Administrator

Up Time : 0 Days 01 Hours 57 Minutes Stat : P+ N+ A+

Smart-UPS 1000 named : On Line, No Alarms Present

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 114 115

No comments

APC SU1400XLT User Manual Page 63