Apc AP9608 User Manual download pdf (Page 11)

3.5 Configure Call-UPS II

Call-UPS II requires on-site configuration before remote operation. You

will be able to change any of the settings later by the remote connection.

Follow these steps to configure Call-

UPS II for:

• Communication parameters

• Password protection

• Time and date

• Paging (optional)

• Dial-back security (optional)

• Event logging (optional)

Initial Logging On

Connect DTE equipment (a dumb terminal or a computer running termi-

nal emulation software) to the Management Port of Call-

UPS II using the

supplied null modem cable. It may be necessary to use an adapter (not

supplied) to connect the

DTE equipment to the null modem cable.

Set the communication parameters of the DTE equipment to

9600 bits per

second, 8 data bits, no parity, and 1 stop bit (

9600, 8, N, 1).

With Call-

UPS II running (Status Indicator on steady), press CTRL + P

(press and hold the CTRL key while pressing the P key). At the prompt:

Enter Password>

Type in APC and press ENTER.

Note: “

APC” is the factory default password for Call-UPS II. If the

default has been changed through previous configuration,

enter the changed password. Call-

UPS II communication is

case sensitive. Enter

APC in upper case.

On correct entry of the password, Call-

UPS II displays the following

information:

---------------------- SMART-UPS 700 --------------------

Call-UPS II by American Power Conversion Corp

Site ID: 12345678

Location: Physical Location of This UPS

Press Any Key To Continue...

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

No comments

Apc AP9608 User Manual Page 11