Apc AP9608 User Manual download pdf (Page 36)

The initial AT comes from Call-UPS II. Do not include it in the Dial

String. In this example, the Dial String is DT9,5551212@. DT instructs

the modem to dial in tone mode. The 9 and comma are only needed when

Call-

UPS II is used with a phone system that requires dialing 9 for an out-

side line. The comma adds a pause. The @ symbol at the end of the pager

phone number sets the modem to “wait for quiet answer” (five seconds

of silence) before entering the number to send to the pager. The

12345678

in the example comes from item number 8, Site ID, on the Call-UPS II

Paging Setup menu. Call-UPS II then issues the Space Character and

Trouble Code shown near the end of the example. For this example, the

pager would show:

12345678 1

Call-UPS II also issues the semicolon at the end of the modem command.

This sends the modem back into command state.

4.7 Paging Setup

When used in conjunction with a modem that understands industry stan-

dard

AT commands, Call-UPS II can be set up to page an operator in case

of trouble, such as on-battery operation or problems with the UPS. To use

paging, choose item 6 on the Main menu menu to bring up the Paging

Setup menu. Select items from the Paging Setup menu, referring to the

screen listing and table later in this section.

Call-

UPS II reports the condition by showing a code on the pager’s dis-

play. Call-

UPS II reports information in this format:

[Site

ID][space character][trouble code]

Site

ID, Space Character, and Trouble Code are among the settings pro-

grammed by the user (see below). When a reportable condition occurs,

Call-

UPS II uses the modem to page an operator. Call-UPS II issues a mo-

dem command string like this:

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 51 52

No comments

Apc AP9608 User Manual Page 36