APC RAID Subsystem SCSI-SATA II Specifications download pdf (Page 37)

Figure 2-9: Drive Tray Front Flap

Step 3. Line the drive tray up with the slot in which you wish to insert it.

Make sure that it is resting on the rails inside the enclosure. Once the

drive tray is lined up with the slot, gently slide it in. This should be

done smoothly and gently.

Step 4. Close the front flap on the drive tray. Make sure the front flap is

closed properly to ensure that the connector at the back of the drive

tray is firmly connected to the corresponding connector on the

backplane. If the front flap is not closed properly, the connection

between the hard drive and the subsystem will not be secure.

Figure 2-10: Installing a Drive Tray

Step 5. Lock the flap into place. Use a flathead screwdriver to turn the key-

lock until the groove on its face is in a vertical orientation. (See

Figure 2-11)

Drive Tray Installation

2-13

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 99 100

No comments

APC RAID Subsystem SCSI-SATA II Specifications Page 37