APC RAID Subsystem SCSI-SATA II Specifications download pdf (Page 40)

cords using these cable clamps to help prevent accidental disconnection of power cords

that could result in costly down time.

2.10.1 Component Description

Each cable clamp consists of the following:

1. A cable strap with a “push barb” anchor mount

2. An adjustable cable clamp

The cable strap is secured to the chassis by inserting the barb anchor into the pre-drilled

hole located under each power supply module. The cable clamp is then secured to the

cable strap and is wrapped around the power cord to hold the subsystem’s power plug in

place to ensure that the power cord connection can withstand shock, vibration and

accidental impact.

Figure 2-14: Cable Clamp and Cable Strap (Cable Mount)

2.10.2 Cable Clamp Installation

Step 1. Connect a power cord to a subsystem power socket so that you can

determine the correct position of the cable clamp along the cable strap.

The diagram below shows the relative positions of a power cord, cable

clamp, and cable strap.

2-16

Power Cord Cable Clamp Installation

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 99 100

No comments

APC RAID Subsystem SCSI-SATA II Specifications Page 40