APC SBPSU10K30FC1M1-WP Installation Manual download pdf (Page 11)

7Smart-UPS® VT and MGE™ Galaxy™ 3500 10-30 kVA 208 V MBP Installation

Installation

Overview

Warning: Review “Safety” on page 1 before starting this installation. Pay strict

attention to all safety warnings and caution notices!

• ALL INTERNAL cable connections were made prior to shipment.

• EXTERNAL cable connections with the UPS need to be made on-site. EXTERNAL cable

connections from the utility also need to be made on-site. EXTERNAL cable is not supplied.

• Control wire connections between the UPS and the MBP additionally need to be made on-site.

Control wires are not supplied.

• Panel board breakers must be ordered separately. Tie-wraps are not supplied.

Tools

The following tools are required for this installation:

Panel board breakers

The 42-position panel board supports the following Square D

1-, 2-, and 3-pole bolt-on circuit

breakers. All of the circuit breakers listed below have been pre-tested and approved by APC.

• Dolly/hand-truck • M10 nut driver

• Tape measure • Standard (flathead)

• Pliers • Phillips screwdriver

• Level • T30 Torx screwdriver

• Marker • 4mm Allen wrench

• Drill • 1/2” socket with ratchet

Breaker Type APC Part# Breaker Type APC Part#

1-pole, 20Amp PD1P20ABBSD 3-pole, 20Amp PD3P20ABBSD

2-pole, 20Amp PD2P20ABBSD 3-pole, 80Amp PD3P80ABBSD

2-pole, 30Amp PD2P30ABBSD 3-pole, 100Amp PD3P100ABBSD

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

No comments

APC SBPSU10K30FC1M1-WP Installation Manual Page 11