APC SBPSU10K30FC1M1-WP Installation Manual download pdf (Page 16)

Smart-UPS® VT and MGE™ Galaxy™ 3500 10-30 kVA 208 V MBP Installation 12

UPS connections.

Note: UPS cables can enter through the top or the bottom of the MBP. However, BOTTOM is

recommended.

Refer to the Smart-UPS VT 10-30kVA or MGE Galaxy 3500, 208V Installation Manual for

MBP cable connections at the UPS.

1. Connect the four UPS inputs [L1, L2, L3, N, top-to-bottom] to the Q1 Switch in the MBP. Use a

4mm Allen wrench and torque to 60in-lbs [7Nm].

2. Connect the four UPS outputs [L1, L2, L3, N, top-to-bottom] to the Q2 Switch in the MBP. Use a

4mm Allen wrench and torque to 60in-lbs [7Nm].

3. Connect the two UPS control wires to Pins 7 and 8 in the MBP Control Terminal Block. Use a

standard (flathead) screwdriver and make the screws hand-tight.

UPS Inputs to Q1

UPS Outputs to

Control Wires [7, 8]

Switch [L1, L2, L3, N]

Q2 Switch [L1, L2, L3, N]







1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

APC SBPSU10K30FC1M1-WP Installation Manual Page 16