APC SBPSU10K30FC1M1-WP Installation Manual download pdf (Page 17)

13Smart-UPS® VT and MGE™ Galaxy™ 3500 10-30 kVA 208 V MBP Installation

Re-attaching the front door

Note: This section applies only if the front door was removed at the start of the installation

process. If you chose not to remove the door, ignore this section.

Re-attaching the front door requires at least two people: one to hold the door in place, and the

other to make the necessary hardware connections.

1. Holding the door at an angle to the MBP enclosure, re-insert the three hinge clips into the three

door hinges.

2. Using your thumb and forefinger, push the three rubber plugs onto the bottom ends of the three

hinge clips.

3. Keeping the door open, re-connect the internal ground cable to the ground stud on the inside of

the door. Place the M6 flange nut over the cable lug on the stud. Use an M10 nut driver and

torque to 120in-lbs [14Nm].

4. Close and lock the front door.

Hinges (3)

Hinge Clips (3)

Rubber Plugs (3)





1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

APC SBPSU10K30FC1M1-WP Installation Manual Page 17