APC 10-30 KVA Installation Manual download pdf (Page 9)

20 kVA - 80 kVA UPS

User’s and Installation Manual

1015543

Revision D

The UPS system must be installed according to the instructions in this manual. Installation

may be performed by qualified personnel only. Failure to recognise the electrical hazards

could prove fatal.

WARNING!

Do not open the UPS cabinet! Some components inside the UPS cabinet carry high

voltages. To touch them may prove fatal. All operations inside the unit must be carried

out only by a service engineer from the manufacturer or from an agent authorised by the

manufacturer.

WARNING!

The UPS is not provided with automatic backfeed isolation. A readily accessible

disconnect device must be installed in the fixed wiring. See chapter 6.5.

User operations

The only user operations permitted are:

• Starting up and shutting down the UPS unit (not the initial start up).

• Operating the user interface.

• Connecting data interface cables.

• Monitoring the UPS with LanSafe III or PowerVision software.

These operations must be performed according to the instructions in this manual. During any

of these operations, the user must take greatest care, and perform only the prescribed

operations. Any deviation from the instructions could be dangerous to the operator.

4. Shipping and storage

The UPS equipment is shipped on specifically designed pallets so that it is easy to move with a

forklift.

Do not stack the pallets.

Because of the high energy stored within batteries, the UPS and the battery cabinet must be

handled with care. The UPS must always be kept in an upright position and must not be dropped.

Because of the heavy weight of the UPS system proper provision must be made for

transportation. See technical specifications for dimensions and weights of the UPS.

If the UPS is not immediately installed the following must be remembered:

• The UPS should be stored in the original packing and shipping carton.

• The recommended storing temperature is between +15°C ... +25°C.

• The equipment must always be protected from moisture and weather.

If the UPS is stored for a longer period of time the batteries of the UPS should be charged for at

least 8 hours every 6 months to maintain the battery condition.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

No comments

APC 10-30 KVA Installation Manual Page 9