APC AR2800BLK Datasheet download pdf (Page 22)

18 NetShelter VS Enclosure

Vertical Mounting Rails

The vertical mounting rails are factory-installed in the proper position for rack-mountable equipment

that has a depth of 29.13 inches (740 millimeters).

On a 600mm-wide enclosure, you can adjust each rail to

the front or rear over a total range of 2.35 inches

(60 millimeters) to accommodate different rails or

equipment with various depths.

You can also move the rails further by attaching them to

the horizontal braces. The following sections describe the

procedures for adjusting the position of the mounting rails

and for moving them within the enclosure.

How to adjust the mounting rails on the frame posts

1. Use the 5-mm hex wrench (provided) to loosen—but not remove—the four pan-head screws in

the slots of each vertical mounting rail.

2. Slide the rails forward or rearward as desired. Use a level to make sure each mounting rail is

vertical. Tighten each screw.

2.35”

(60 mm)

Warn

To avoid personal injury or damage to the enclosure, perform this procedure with

no equipment installed on the vertical mounting rails.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

No comments

APC AR2800BLK Datasheet Page 22