APC AR2800BLK Datasheet download pdf (Page 30)

26 NetShelter VS Enclosure

How to Move the Baying Hardware

Baying trim

The baying hardware is pre-installed on both sides of the enclosure

without sides. The baying trim  is pre-installed on the front-right post

of the enclosure without sides, using the baying brackets. When joining

an enclosure with sides to an enclosure without sides, you will need to

move some of the baying hardware.

The procedures for moving baying hardware vary according to whether

the enclosure with sides is to the right or left of the enclosure without

sides. If the enclosure with sides is on the right, you do not move the trim.

When the enclosure with side panels is on the left

1. Carefully slide the enclosures apart.

2. Remove the right side panel of the enclosure with sides.

3. Remove the pan-head socket

screws and nuts that hold the

baying brackets to the front-right

vertical frame of the enclosure on

the right. Leave the baying trim

attached to the brackets. Save the

two pan-head socket screws and

nuts for use in the next step.

Note

When a procedure refers to an enclosure on the right or an enclosure on the left, the

point of orientation is always from the front.



See “How to Remove and Install the Side Panels” on page 11.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

No comments

APC AR2800BLK Datasheet Page 30