APC SU3000RMXLI3U User Manual download pdf (Page 20)

6: TRANSPORTING YOUR SMART-UPS

REMOVING THE UPS FROM THE RACK

Always DISCONNECT THE BATTERY before shipping the UPS to avoid damage

during transport. (U.S. Federal Regulation requires that batteries are disconnected

during shipment.) The battery may remain in the UPS; it does not have to be re-

moved.

This requirement applies whether the UPS is shipped alone or installed in an

equipment rack or system.

REMOVING THE FRONT BEZEL

1. Shut down any equipment attached to the UPS.

2. Disconnect the UPS from the power supply.

3. If you are using the original UPS packaging, you

must transport the front bezel separate from the

UPS.

Remove the front bezel. Use both hands and

grasp the finger clips on either side of the bezel.

Pull it toward you. The bezel will unsnap from

the UPS.

EMOVING THE UPS FROM THE RACK

Due to its weight, removing the UPS from a rack requires two people.

1. Remove the four rack screws (two screws on each

mounting bracket) that secure the UPS to the

rack.

2. Grasp the battery module handle and pull it to-

ward you to pull the UPS out far enough to sup-

port the front of the UPS from the underside.

3. Use the handles on the sides of the UPS for addi-

tional support. Continue to pull the UPS out of

the rack while a second person supports the rear

underside.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25

No comments

APC SU3000RMXLI3U User Manual Page 20