APC SU3000RMXLI3U User Manual download pdf (Page 7)

5. Connect the battery and attach the front bezel.

6. Connect the equipment and power to the UPS.

7. Turn on the UPS.

NSTALLING THE MOUNTING RAILS IN THE RACK

Install the mounting rails in the rack. Directions are included with the rail kit. The UPS comes with

standard 19-inch (46.5 cm) rack mounting rails, brackets, and cleats. The rack can have any of the

common types of equipment mounting holes (square, round-threaded, or round-non-threaded). All

necessary hardware is provided.

EMOVING THE BATTERY MODULE

The UPS is heavy. To lighten it, remove the battery module before mounting the unit in the rack.

Due to its weight, two people are required to remove the battery module.

The battery module is accessible from the front of

the UPS (shown at left).

This procedure requires a Phillips screwdriver.

1. If the UPS has been in operation, locate the white

cord  attached to the battery module connector

plug . Grasp the cord and pull firmly toward

you until the connector plug is disconnected.

DO NOT pull the battery module cables.

If the UPS has not been in operation, the battery

will not yet be connected. The UPS ships with

the battery disconnected.

2. Use a screwdriver to remove the two battery

module mount screws located at the top corners

of the face plate .

Set the screws aside in a safe place. You will re-

place them later.









1 2 3 4 5 6 7 8 9 10 11 12 ... 24 25

No comments

APC SU3000RMXLI3U User Manual Page 7