APC ACRD200 Installation Manual download pdf (Page 37)

29InRow RD Fluid Cooled Operation and Maintenance

BOOTP. For the Network Management Card to use a BOOTP server to configure its TCP/IP settings, it

must find a properly configured RFC951-compliant BOOTP server.

1. In the BOOTPTAB file of the BOOTP server, enter the MAC address of the Network

Management Card, the IP addresses of the subnet mask, default gateway, and an optional bootup

file name. For the MAC address, look on the nameplate of the InRow RD or on the Quality

Assurance slip included in the package.

2. When the Network Management Card reboots, the BOOTP server provides it with the TCP/IP

settings.

– If you specified a bootup file name, the Network Management Card attempts to transfer that

file from the BOOTP server using TFTP or FTP. The Network Management Card assumes all

settings specified in the bootup file.

– If you did not specify a bootup file name, you can configure the other settings of the Network

Management Card remotely through its Web interface or control console; user name and

password are both apc, by default.

See your BOOTP server documentation to creat a bootup file.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

No comments

APC ACRD200 Installation Manual Page 37