APC ACRD200 Specifications download pdf (Page 21)

13InRow Fluid Cooled RD Installation

Connections Overview

All connections to and from the equipment can be made through either the top or the bottom of the

equipment. Once the connectors are sweated or soldered into place, the equipment can be connected and

disconnected without soldering, welding, or gluing. See the following tables for information about the

sizes and types of connectors.

Warning: Make electrical connections in accordance with all local and national codes.

Power connections

Piping connections

Insulation

Apply provided insulation to water lines to protect personnel and to minimize condensation.

Note: Using either tape or glue, completely seal the insulation boots covering the unused

supply and return connections.

Model Voltage

Frequency

(Hz) MCA MOP FLA

LRA

(Compressor)

ACRD200

208-240 60 25 40 N/A 87.5

ACRD201

220-240 50 N/A N/A 28 N/A

Above data is based on maximum operating conditions.

Consult local and national codes for wire size, conduit requirements and overload protection.

MCA - Minimum Circuit Ampacity

MOP - Maximum Overcurrent Protection

FLA - Full Load Amps

LRA - Locked Rotor Amps

Connection Type ACRD100/101

Fluid input

Brazed* 7/8-in OD (nominal) copper

Fluid return

Brazed* 7/8-in OD (nominal) copper

Condensate drain

3/16-in ID

5/16-in OD

* Use the provided gaskets to prevent leakage.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

No comments

APC ACRD200 Specifications Page 21