APC RAID Subsystem SCSI-SATA II User Manual download pdf (Page 172)

SAS / SATA II NAS System

172

User’s Manual

8.4.4.3 IP Address

This option allows you to set a certain range of hosts to have an access into proNAS.

By default, the IP address is set to *.*.*.* which means that it will accept

connections from any host. If set to 192.168.100.*, this will only allow connections

from your private network 192.168.100 and all other connections will be refused.

NOTE: Not all ACL permission settings may be applicable to all

share protocols. If you set NFS protocol, it can support all ACL

setting mentioned above. If you set CIFS protocol, read only IP

address will not be honored.

Sample Steps to Limit Share Connections to Selected IP Range:

1. Select Share Manager. Select the share name where account will be giver

permission, and click Privilege tab.

2. Click “Edit”. Select IP Address tab.

NOTE: BY default, all IP addresses (*.*.*.*) have Read/Write access

to the NAS. If you restrict NAS connections from specific IP range,

only the selected IP range can access the NAS share. Group

Permission or User Account Permission is still needed to be assigned

in order for users to gain access to the share folder.

3. To remove *.*.*.*, select “*.*.*.*” from Permission list and click “REMOVE”.

4. To add an IP range, enter the IP range (e.g.: 192.168.1.*) in the “IP Address”

box, check the “Write” box to assign Read-Write access if necessary, and click

“ADD”.

5. Click “Save” when done.

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 258 259

No comments

APC RAID Subsystem SCSI-SATA II User Manual Page 172