APC RAID Subsystem SCSI-SATA II User Manual Page 28
- Page / 259
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
SAS / SATA II NAS System
28
User’s Manual
Chapter 3 Getting Started with the NAS System
3.1 Connecting the NAS to your Network
1. For purpose of RAID configuration, attach network cable to the R-Link port.
Connect the other end to your network hub or switch. Alternatively, you may use
the Monitor port and connect the serial cable from the Monitor port to any
available COM port of a PC.
2. Attach network cable to the Ethernet port LAN0. Connect the other end to your
network hub or switch. You may also connect the other Ethernet port if needed.
3.2 Powering On
NOTE: If other JBOD subsystem(s) or RAID subsystem, with or
without JBOD subsystem(s) connected in daisy-chain, are to be
connected to the SAS Expansion Port or to the SAS HBA Port
respectively, the JBOD subsystems or RAID subsystem (and its
JBOD subsystem(s) must be powered on first before the NAS. This
is to detect the disk drives from the JBOD subsystem or the
volumes from the RAID subsystem. Refer to Section 3.4 for more
information.
1. Plug in the 2 power cords into the AC Power Input Socket located at the rear of
the NAS system.
- SAS/SATA II NAS System 1
- Table of Contents 2
- Preface 7
- FCC Compliance Statement 8
- Before You Begin 9
- SAS / SATA II NAS System 10
- User’s Manual 10
- Chapter 1 Introduction 11
- 1.1 Key Features 12
- 1.3 RAID Concepts 16
- RAID Management 20
- 1.4 Array Definition 21
- 1.5 High Availability 22
- 3.2 Powering On 28
- 3.3 Installing Hard Drives 30
- Main Menu 37
- Chapter 5 RAID Management 47
- 5.2 RAID Set Functions 49
- 5.2.2 Delete RAID Set 50
- 5.2.4 Offline RAID Set 54
- 5.2.6 Create Hot Spare 57
- 5.2.7 Delete Hot Spare 57
- 5.2.8 Rescue Raid Set 58
- 5.3 Volume Set Function 59
- 5.3.2 Create Raid 30/50/60 62
- 5.3.3 Delete Volume Set 63
- 5.3.4 Modify Volume Set 64
- 5.3.5 Check Volume Set 67
- 5.3.7 Stop Volume Check 70
- 5.4 Physical Drive 71
- 5.4.4 Identify Enclosure 73
- 5.5 System Controls 75
- 5.5.4 SNMP Configuration 79
- 5.5.5 NTP Configuration 80
- 5.6 Information Menu 84
- 5.6.2 System Information 85
- 5.6.3 Hardware Monitor 86
- PART II proNAS System 95
- Chapter 7 Introduction 96
- Chapter 8 proNAS Manager 104
- 8.1 Volume Manager 105
- 8.1.3 Volume Snapshot 118
- 8.1.3.3 Delete Snapshots 124
- 8.1.4 Volume Replication 126
- 8.1.5 iSCSI 134
- 8.2 Network Manager 142
- 8.2.2 Internet Gateway 146
- 8.2.3 SNMP/MRTG 147
- 8.2.4 Network Test 148
- 8.3 Account Manager 149
- 8.3.1.3 NIS Authentication 152
- 8.4 Share Manager 161
- 8.4.1 Share Management 162
- 8.4.1.2 Applying ACL 163
- 8.4.1.3 Modifying a Share 163
- 8.4.1.4 Deleting a Share 164
- 8.4.3 Protocol Setting 167
- 8.4.3.2 NFS 168
- 8.4.4.1 Group 169
- 8.4.4.2 Account 170
- 8.4.4.3 IP Address 172
- 8.4.6 Duplication 179
- 8.4.7 Default Share 183
- 8.5 System Manager 184
- 8.5.3 Report tab 187
- 8.5.4 Time tab 188
- 8.5.5 Serial Ports tab 189
- 8.5.6 Power tab 190
- 8.5.7 Reboot tab 191
- 8.5.8 Service tab 192
- 8.5.9 Status tab 195
- 8.6 Backup Manager 197
- 8.6.3 Tape Control 204
- 7. Click “Save” again 207
- 8.7 Log Manager 221
- 8.8 Event Manager 222
- Event Purpose 223
- Chapter 9 File Manager 225
- 9.2 Logon to File Manager 227
- Chapter 10 proBackup 231
- 10.3 Create Backup Plan 234
- 10.4 Restore Backup 240
- 10.5 Account Detail 241
- 11.3 ProNAS HA Properties 254
- 11.6 License Registration 258
- 11.7 Event Log Properties 259
Related products and manuals for Networking APC RAID Subsystem SCSI-SATA II
Networking APC Metered Rack User's Guide
(110 pages)
(110 pages)
Networking APC WMR1000B User Manual
(318 pages)
(318 pages)
Networking APC AP9606 User's Guide
(84 pages)
(84 pages)
Networking APC AP9613 Installation Manual
(36 pages)
(36 pages)
Networking APC AP9470 Installation Manual
(32 pages)
(32 pages)
Networking APC AP9622 Installation Manual
(28 pages)
(28 pages)
Networking APC IP DSLAM User's Guide
(603 pages)
(603 pages)
Networking APC AP9606 Quick Start Manual
(20 pages)
(20 pages)
Networking APC AP9312TH User's Guide
(32 pages)
(32 pages)
Networking APC AP9608 Installation Manual
(32 pages)
(32 pages)
© 2020, manymanuals.com. All rights reserved. | 3.346 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals