APC Automatic Disconnect Switch Specifications download pdf (Page 21)

Automatic Transfer Switch with Power Distribution 11

ATS with Power Distribution

Front view, door closed



Twenty knockouts are provided on the

roof, the sides, and on the floor of the

ATS for running utility mains and

generator conductors and for distributing

power to equipment in your data center.

Connecting conduit to the ATS does not

require drilling; use a knockout punch to

enlarge a knockout, if necessary.



The user connection plate is connected

to the ATS monitoring unit, and provides

easy access to input contact, relay output,

network, and EPO connections. Make

connections from inside the enclosure,

and route wires through the knockout

provided on the plate. See “User

connection plate” on page 16 for more

information.



The bottom access panel can be

removed for access to the panel board.

Use a #2 Phillips screwdriver to remove

the two M6 flat-head screws securing the

panel to the enclosure.



The perforated steel front door has a

Plexiglas plate protecting access to the

switches, circuit breakers, and the

display interface. If you want to access

the display interface without opening the

front door, you can remove the rectangle

of Plexiglas covering the display

interface. See page 67 for instructions.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 101 102

No comments

APC Automatic Disconnect Switch Specifications Page 21