APC Automatic Disconnect Switch Specifications download pdf (Page 61)

Automatic Transfer Switch with Power Distribution 51

Configuring the ATS Network Management

Interface

Connect the ATS to your network

1. Connect a Cat-5 network cable to the surge-protected ethernet port on the ATS user connection

plate. The arrow in the illustration below is pointing to the port. The figure on page 11 shows

the location of the user connection plate on the roof of the ATS.

You can make connections from inside the enclosure, or you

can remove the user connection plate and make your

connections. Remove the plate using a Phillips or standard

screw driver to loosen the two captive screws. Use the

knockout in the plate to route cables to and from the user

connections on the plate. If you remove the plate, make sure

that you do not disturb the existing connections.

2. Run the connected Cat-5 network cable through knockout in the user connection plate to your

network connection.

3. Configure the TCP/IP settings of the ATS. See “Configuration Overview” on page 52 for

further instructions.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 101 102

No comments

APC Automatic Disconnect Switch Specifications Page 61