APC RAID Subsystem SCSI-SATA II User Manual download pdf (Page 250)

SAS / SATA II NAS System

250

User’s Manual

12. Wait until the

status of the local

and peer server

are in be standby-

standby mode

respectively. The

statuses of the

private net must

also be "Enabled

and Healthy". If

this is not the

output, check and

repeat previous

steps.

13. Go to "Resource Group Manager" then press "Add Resource Group".

The Resource Group Manager of proNAS HA is used to manage resource

groups. Users need to configure resource groups only on one of the servers,

usually the Active server. proNAS HA will automatically synchronize the status

of resource groups between both servers. Note that users are prohibited to

create or remove resource groups unless proNAS HA are running on both

servers and at least one of the private net is functioning.

Buttons:

Add

Resource

Group button

Add new resource group member. User can specify the

name of the resource group. This name must be unique

for the resource groups within the cluster

Switch All

Resource

Groups from

Peer

This is to manually takeover the all resource groups from

the peer server. Users can manually takeover resource

groups from the peer server to perform maintenance or

troubleshooting on the active server. This button will be

displayed only if resource groups are bring in.

Switch All

Resource

Groups to

Peer

This is to manually failover the all resource groups to the

peer server. Users can manually failover resource groups

to the peer server to perform maintenance or

troubleshooting on the active server. This button will be

displayed only if resource groups are bring in.

1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 258 259

Comments to this Manuals

No comments

APC RAID Subsystem SCSI-SATA II User Manual Page 250

Comments to this Manuals

Related products and manuals for Networking APC RAID Subsystem SCSI-SATA II