SAS / SATA II NAS System
User’s Manual
33
Chapter 4 RAID Configuration Utility Options
Configuration Methods
There are four methods of configuring the RAID controller:
a.
VT100 terminal connected through the serial Monitor port
b.
Front panel touch-control buttons
c.
Web browser-based remote RAID management via the R-Link Ethernet port
d.
Telnet connection via the R-Link Ethernet port
NOTE: The RAID subsystem allows you to access using only one
method
at a time. You cannot use more than one method at the
same time.
4.1 Configuration through Terminal
Configuring through a terminal will allow you to use the same configuration options
and functions that are available from the LCD panel and via Telnet. To start-up:
1. Connect the Monitor port located at the rear of the system to another PC or a VT100
compatible terminal operating in an equivalent terminal emulation mode using serial
cable.
NOTE: You may connect a terminal while the system’s power is on.
2. Power-on the terminal.
3. Run the VT100 program or an equivalent terminal program.
Comments to this Manuals