APC MGE Galaxy 7000 User Manual download pdf (Page 52)

Network Management Card & Modbus/Jbus 34022321XT indice :AD Page 52/91

Network Management Teleservice Card

APC by Schneider Electric

www.apc.com

6.5.2 Environment Status

For both measurements, a graduated gauge proposes the following functions:

The cursor indicates the current value.

Two red zones to the left and right represent the high and low thresholds that can be set on the Environment Settings page.

When the measured value enters one of these zones, an alarm can be notified (see Notification parameter in the Environment Settings page).

Time-stamped minimum and maximum temperatures show the extreme values recorded since the last Reset Min/Max, a thin dotted line

shows their positions on the gauge.

Min and Max can be forced at any time to the current value by clicking on the Reset Min/Max button.

Calibrate: The sensor is factory-calibrated, but the user can apply an offset to adjust the measurement.

Input #1 and Input #2 show the position of the two contacts acquired by the sensor.

The position is displayed with the parameters entered in the Environment Settings page.

The last status change of each contact is time-stamped.

The Internet browser updates this page every 10 seconds

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 90 91

No comments

APC MGE Galaxy 7000 User Manual Page 52