APC NETBOTZ NBRK0200 Specifications download pdf (Page 26)

NetBotz Rack Monitor 200 Installation and Quick Configuration Manual22

Recover from a Lost Password

You can use a local computer (a computer that connects to the NetBotz 200 through the serial port) to

access the control console.

1. Select a serial port at the local computer, and disable any service that uses that port.

2. Connect the provided RS-232 configuration cable to the selected port on the computer and to the

RS-232 Console Port at the NetBotz 200.

3. Run a terminal program (such as HyperTerminal) on your computer and configure the selected

port for 9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control.

4. Press

ENTER, repeatedly if necessary, to display the User Name prompt. If you are unable to

display the User Name prompt, verify the following:

– The serial port is not in use by another application.

– The terminal settings are correct as specified in step 3.

– The correct cable is being used as specified in step 2.

5. Press the Reset switch. The Status LED will flash alternately orange and green. Press the Reset

button a second time immediately while the LED is flashing to reset the user name and password

to their defaults temporarily.

6. Press

ENTER as many times as necessary to redisplay the User Name prompt, then use the default,

apc, for the user name and password. (If you take longer than 30 seconds to log on after the User

Name prompt is redisplayed, you must repeat step 5 and log on again.)

7. From the Control Console menu, select System, then User Manager.

8. Select Administrator, and change the User Name and Password settings, both of which are

now defined as apc.

9. Press

CTRL+C, log off, reconnect any serial cable you disconnected, and restart any service you

disabled.

Clean the NetBotz 200

To clean the device, gently wipe surfaces with a clean, dry cloth.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

No comments

APC NETBOTZ NBRK0200 Specifications Page 26