APC AR2316BLK Datasheet download pdf (Page 23)

NetShelter VX Enclosure: Unpacking, Installation, Customization 19

Vertical Mounting Rails

The vertical mounting rails are factory-installed in the proper position for use with rack-mountable

equipment that has a depth of 29.13 inches (740mm).

On a 600mm wide enclosure or a 750mm wide enclosure

configured for 23 inch equipment, you can adjust each rail

to the front or rear over a total range of 2.35 inches

(60mm) to accommodate different rails or equipment with

various depths.

On a 750mm wide enclosure configured for 19 inch

equipment, you can adjust each rail over a total range of

1 inch (25mm).

You can also move the rails further by attaching them to

the horizontal braces. The following sections describe the

procedures for adjusting the position of the mounting rails

and for moving them within the enclosure.

How to adjust the mounting rails on the frame posts

1. Use the 5-mm hex wrench (included) to loosen—but not remove—the four pan-head screws in

the slots of each vertical mounting rail.

2. Slide the rails forward or rearward as desired. Use a level to make sure each mounting rail is

vertical. Tighten each screw.

2.35 in.

(60 mm)

1”

(25 mm)

Warning

To avoid personal injury or damage to the enclosure, perform this procedure with

no equipment installed on the vertical mounting rails.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

No comments

APC AR2316BLK Datasheet Page 23