APC NETWORKAIR ACPA4000 User Manual download pdf (Page 7)

NetworkAIR

ACPA4000 User Manual 1

Introduction

About the NetworkAIR ACPA4000

APC

’s NetworkAIR ACPA4000 is a portable, compact air conditioner designed for spot-cooling,

emergency-cooling, and after-hours cooling of server closets, data centers, conference rooms, home

offices, or rooms that house heat-sensitive equipment.

The ACPA4000 provides 3.8 kwh (13000 BTU/hour) of cooling power. It automatically adjusts room

temperature and reduces moisture while filtering the air. Additional features of the portable air

conditioning unit include:

• Electronic control panel with LCD display

• On/Off scheduling

• Automatic restart

• Dual condenser ducts for inlet and exhaust

• High-head pressure cut-out to prevent compressor damage

• Hot gas bypass to prevent coil freeze-up

Safety

Warning

Use the unit on a flat surface.

Do not obstruct the air outlets of the unit.

For indoor use only.

Do not attempt to service the unit except to clean and replace the air filters. The unit

contains no other user-serviceable parts.

Do not place the rear of the unit less than 8 inches (203 milimeters) away from any

wall or obstacle.

Do not install the air conditioner where there are fumes or flammable gases, or in an

extremely humid space such as a greenhouse.

Do not place this unit on its side. If the unit has been tipped, place it upright on a flat,

solid surface and keep it in this position for a minimum of 12 hours before operating.

Connect the unit to a 3-wire AC outlet (two poles plus a ground). The receptacle

must be connected to an appropriate branch circuit, 115 volt, 60Hz, 20 Amp main

protection (fuses/circuit breaker). Connection to any other power source may result

in a shock hazard.

The unit should only be used with the supplied power cord.

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

No comments

APC NETWORKAIR ACPA4000 User Manual Page 7