APC Smart-UPS C 1000VA LCD 120V Specifications download pdf (Page 11)

Smart-UPS C 1000/1500 VA 120 Vac Tower 9

Service

If the unit requires service, do not return it to the dealer. Follow these steps:

1. Review the Troubleshooting section of the manual to eliminate common problems.

2. If the problem persists, contact APC Customer Support through the APC Web site,

www.apc.com.

a. Note the model number and serial number and the date of purchase. The model and serial

numbers are located on the rear panel of the unit and are available through the LCD display

on select models.

b. Call APC Customer Support and a technician will attempt to solve the problem over the

phone. If this is not possible, the technician will issue a Returned Material Authorization

Number (RMA#).

c. If the unit is under warranty, the repairs are free.

d. Service procedures and returns may vary internationally. Refer to the APC Web site for

country specific instructions.

3. Pack the unit properly to avoid damage in transit. Never use foam beads for packaging. Damage

sustained in transit is not covered under warranty.

a. Always DISCONNECT THE UPS BATTERY before shipping in compliance with

U.S. Department of Transportation (DOT) and IATA regulations. The battery may

remain in the unit.

b. Internal batteries may remain connected in the XLBP during shipment, if applicable, not all

units have XLBPs.

4. Write the RMA# provided by Customer Support on the outside of the package.

5. Return the unit by insured, pre-paid carrier to the address provided by Customer Support.

Transport the unit

1. Shut down and disconnect all connected equipment.

2. Disconnect the unit from utility power.

3. Disconnect all internal and external batteries (if applicable).

4. Follow the shipping instructions outlined in the Service section of this manual.

1 2 ... 6 7 8 9 10 11 12 13 14

No comments

APC Smart-UPS C 1000VA LCD 120V Specifications Page 11