APC Smart-UPS C 1000VA LCD 120V Specifications download pdf (Page 6)

Smart-UPS C 1000/1500 VA 120 Vac Tower4

Power-Saving LCD Screen

The display interface can be configured to remain continuously illuminated or to extinguish after a

period of inactivity to save electricity.

1. Continuous Illumination mode: Press and hold the

DISPLAY

button for two seconds. The display

will illuminate and the UPS will beep to confirm Continuous Illumination mode is activated.

2. Power-Saving mode: Press and hold the

DISPLAY

button for two seconds. The display will

extinguish and the UPS will beep to confirm Power-Saving mode is activated. While in

Power-Saving mode, the display will illuminate if a button is pressed, it will extinguish after 60

seconds of inactivity.

Smart-UPS sensitivity settings

The Smart-UPS detects and reacts to line voltage distortions by transferring to battery power to protect

connected equipment. In situations where either the UPS or the connected equipment is too sensitive for

the input voltage level it is necessary to adjust the transfer voltage.

1. Connect the UPS to a utility power source. Be sure the UPS is turned off.

2. Press and hold the

POWER

button for six seconds. The load capacity bar will flash on and off, to

indicate the UPS is in Program mode.

3. Press the

POWER

button again to scroll through the menu options. The UPS will beep to confirm

the selection.

Refer to the table for an explanation of the transfer voltage sensitivity levels.

Low sensitivity Medium sensitivity High sensitivity (Default)

97-136 Vac 103-130 Vac 106-127 Vac

Use this setting with equipment

that is less sensitive to fluctuations

in voltage or waveform distortions.

Use this setting under normal

operating conditions.

Use this setting when connected

equipment is sensitive to any minor

fluctuations in voltage or waveform

distortions.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

APC Smart-UPS C 1000VA LCD 120V Specifications Page 6