APC AP9630 User's Guide download pdf (Page 36)

34UPS Network Management Card 2 User’s Guide

The NMC supports up to four inputs. You must specify the input that will be associated with this event.

5. In the Port drop-down list, select the Universal Sensor Port number (1 or 2) to which the Dry Contact

I/O Accessory is installed.

6. In the Zone drop-down list, select the zone letter (A or B) of the contact to which the input is installed.

7. Define the action the UPS will perform (if any) when the input changes state.

8. Select the output that will open or close (if any).

9. Click Save Policy.

The action you configure occurs once.

If you restore the output to its normal state before the alarm condition clears, the output will not

open or close again unless the alarm condition clears and then reoccurs.

Security menu

Session Management screen

Path: Configuration > Security > Session Management

Enabling Allow Concurrent Logins means that two or more users can log on at the same time. Each user has

equal access

and each interface (HTTP, FTP, telnet console, serial console (CLI), etc.) counts as a

logged-in user.

Remote Authentication Override: The NMC supports Radius storage of passwords on a server. However, if

you enable this override, the NMC will allow a local user to log on using the password for the NMC that is

stored locally on the NMC. See also “Local Users” and “Remote Users authentication”.

Ping Response

Path: Configuration > Security > Ping Response

Enable the IPv4 Ping Response check box to allow the Network Management Card 2 to respond to network

pings. This does not apply to IPv6.

Local Users

Use these menu options to view, and to set up access and individual preferences (like displayed date format), to

the NMC user interfaces. This applies to users as defined by their logon name.

Path: Configuration > Security > Local Users > Management

Setting user access.

With this option an administrator or super user can list and configure the users allowed

access to the UI. Click on the name link to view details, and to edit or delete a user.

Click on Add User to add a user. On the resulting User Configuration screen, you can add a user and

withhold access by clearing the Access check box. The maximum length for both the name and password is 64

bytes, with less for multi-byte characters. You have to enter a password.

Values greater than 64 bytes in Name and Password might get truncated!

To change an administrator/ super user setting, you must enter all three password fields.

Use Session Timeout to configure the time that this UI waits before logging off this user (three minutes by

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 84 85

No comments

APC AP9630 User's Guide Page 36