APC SmartSlot AP9604SR Operations Instructions download pdf (Page 8)

5. Final Installation

1. Use either the supplied accessory connection board or a male 25

pin D connector (not supplied) to make connections to the Smart-

Slot Relay I/O Module. To use a male 25 pin D connection see

section 6 for the connector pinout. To use the supplied accessory

connection board see figure 2 below. Note the use of tie wraps to

secure the connecting wires to the board. The connection board

accepts 16 AWG to 28 AWG wires.

Figure 2, accessory connection board wire dress

2. See sections 6, 7, and 8 for information on how to set up Smart-

Slot Relay I/O Module input wiring. Make all connections to

either the 25 pin D connector or accessory connection board

before continuing.

Caution!

The SmartSlot Relay I/O Module is sensitive to static

electricity. Handle the SmartSlot Relay I/O Module by the end

plate only. Do not touch the exposed printed circuit board.

4. While it is not possible to install the SmartSlot Relay I/O Module

upside down, it is possible to damage it in the attempt. Observe

the correct orientation of the SmartSlot Relay I/O Module as

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

No comments

APC SmartSlot AP9604SR Operations Instructions Page 8